Raption
76
Instruction Manual
Go to Status → Network → LAN → DHCP Leases and pay attention to IP addresses
At ‘DHCP Leases’ check that the modem has detected the automatic IP address and MAC
number for both, your Service PC and the Charge Point.
NOTES:
1.- If the modem has not detected the automatic IP address, switch off the Q10.1 circuit
breaker for Raption 50 (Q14.3 in case of Raption 50 HV, Raption 50 EVO and Raption 100),
wait for 10 seconds and switch on again. Connect again your Service PC to the access point
named ChargePoint_xxxxxxxxxxxx, and repeat the steps 4.3 and 4.6.
2- To make sure that the Charge Point’ s MAC number is correct, it can be seen in one label
behind the HMI screen.
To Next Page
Loading...
