Cisco 10000-2P2-2DC - Page 18

Contents
xviii
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Configuring Ethernet over MPLS 20-19
Ethernet over MPLS Restrictions 20-20
Configuring Ethernet over MPLS in VLAN Mode 20-20
Configuring Ethernet over MPLS in Port Mode 20-21
IEEE 802.1Q Tunneling for AToM—QinQ 20-22
Prerequisites for IEEE 802.1Q Tunneling (QinQ) for AToM 20-23
Restrictions for IEEE 802.1Q Tunneling (QinQ) for AToM 20-23
Ethernet VLAN Q-in-Q AToM 20-23
Configuration Examples 20-25
Verifying QinQ AToM 20-25
Remote Ethernet Port Shutdown 20-25
Restrictions for Configuring Remote Ethernet Port Shutdown 20-26
Configuring Remote Ethernet Port Shutdown 20-26
Configuring Ethernet over MPLS with VLAN ID Rewrite 20-27
Configuring Frame Relay over MPLS 20-28
Configuring Frame Relay over MPLS with DLCI-to-DLCI Connections 20-28
Configuring Frame Relay over MPLS with Port-to-Port Connections 20-29
Enabling Other PE Devices to Transport Frame Relay Packets 20-30
Configuring Frame Relay-to-Frame Relay Local Switching 20-31
Configuring Frame Relay for Local Switching 20-32
Configuring Frame Relay Same-Port Switching 20-33
Verifying Layer 2 Local Switching for Frame Relay 20-34
Configuring QoS Features 20-34
Configuring HDLC and PPP over MPLS 20-36
Restrictions for HDLC over MPLS 20-36
Restrictions for PPP over MPLS 20-36
Configuring HDLC over MPLS or PPP over MPLS 20-36
Estimating the Size of Packets Traveling Through the Core Network 20-37
Estimating Packet Size—Example 20-38
Changing the MTU Size on P and PE Routers 20-38
Setting Experimental Bits with AToM 20-38
Configuring QoS Features 20-40
Monitoring and Maintaining L2VPN 20-43
Configuration Example—Frame Relay over MPLS 20-44
Any Transport over MPLS—Tunnel Selection 20-47
Configuration Example—Any Transport over MPLS: Tunnel Selection 20-47
CHAPTER 21 Configuring L2VPN Interworking 21-1
Bridged Interworking 21-1