Cisco 10000-2P2-2DC - Page 598

Index
IN-2
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Acct-Session-ID RADIUS attribute 16-40
Acct-Status-Type RADIUS attribute 5-40, 16-40
Acct-Tunnel-Connection RADIUS attribute 5-39
Acct-Tunnel-Packets-Lost RADIUS attribute 5-39
ACE,See ACE
ACL
definition 1-1
IP receive 12-1
named 12-7
reflexive 12-2
See also IP receive ACLs
See also time-based ACLs
time-based 12-2, 12-4
address pool
DHCP-based address assignment 10-3
for PPP 10-5
global default pooling mechanism 10-7
leases 10-3
local 10-2
local, definition 1-6
RADIUS-based address assignment 10-2
scope 10-3
ADSL 1-1
agent remote ID 3-9
alarms
critical 14-31
LAIS 14-31
Allow-AS-in BGP 4-10
APS, multirouter 1-27, 1-6
aps force command 14-27
aps manual command 14-27, 14-31
ARP
disabling gratuitous ARP requests 2-11
associate slot command 14-29
Asymmetric Digital Subscriber Line 22-18
asymmetric digital subscriber line
See ADSL
asynchronous transfer mode 1-1
ATM 1-1
line cards, maximum VCs supported 2-16, 8-16
ATM adaptation layer
See AAL5
ATM aggregation
leased-line architecture 1-11
ATM line cards
VC scaling
ATM PVC autoprovisioning 8-4
hierarchical shaping 2-8
atm over-subscription-factor command 8-17
atm pppatm passive command 2-19
ATM PVC autoprovisioning
enabling on PVC within a PVC range 8-10
VC scaling 8-4
ATM PVC autoprovisioning feature
enabling on PVC range 8-9
monitoring 8-12
overview 8-1
restrictions 8-5
atm pxf queuing command 2-16
ATM-to-ATM local switching 20-15
ATM-to-ATM PVC local switching 20-14
AToM 1-21, 20-1
Graceful Restart 20-1
Tunnel selection 20-2
AToM feature
AAL5 over SDU Support over MPLS 20-14
Ethernet over MPLS 20-19
Frame Relay over MPLS 20-28
HDLC over MPLS 20-36
line cards 20-4
PPP over MPLS 20-36
pseudowire connections 20-12
setting EXP bits 20-38
setting the MTU 20-37
transport types 20-3
what is not supported 20-5
AToM header 20-37
attachment circuits 20-2