Cisco 10000-2P2-2DC - Page 620

Index
IN-24
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
topology
hub and spoke 4-22, 4-26, 4-27
TOS field
definition 1-10
preserving 9-5
reflection for multihop feature 9-1
traceroute command 3-43
traceroute vrf command 3-46
traffic
separating 5-22
transmit retries range 16-42
configuring 16-43
show and debug commands 16-44
Transport header 20-37
transport types
supported by AToM 20-3
trap 1-10
trunk interface input hold queue 2-15
TTL 3-46
tunnel 1-10
accounting
configuration example 5-48
feature overview 5-25
authentication
configuration example 5-50
feature overview 5-25
authorization and authentication sequence 5-26
displaying active tunnels 5-37
service authorization
configuring 5-15
description of 5-4
verifying RADIUS service profile 5-15
sharing,configuring in RADIUS service profile 5-13
sharing feature 5-4
specifying maximum sessions 5-36
switch, definition of 1-10
terminating from the LAC 5-36
terminating in VRF 27-1
vrf command 27-2, 27-3
VRF feature 27-1
configuration examples 27-4
configuring 27-3
Tunnel-Client-Endpoint RADIUS attribute 5-39
tunnel-client-endpoint RADIUS attribute 16-41
tunnel destination command 27-3
tunnel-preference attributes 5-6
Tunnel Selection 20-47
Configuration Example 20-47
debug mpls l2transport vc command 20-47
disable-fallback option 20-47
MPLS traffic engineering tunne 20-47
preferred-path sub-command 20-47
virtual circuits 20-47
Tunnel-Server-Endpoint attribute 5-6
Tunnel-Server-Endpoint RADIUS attribute 5-39
tunnel-server-endpoint RADIUS attribute 16-41
turbo access control lists 1-10
two-rate policer 1-25
U
UBR
definition 1-10
ubr command 2-15, 8-3
unequal cost load balancing 4-2
Unicast Reverse Path Forwarding 13-11
functionality 13-11
UNI signaling 1-10
unspecified bit rate
definition 1-10
upgrading to 12.2(28)SB 1-25
upstream rate 1-10
upstream VRF 4-22, 4-24
uRPF
Configuring Loose Mode uRPF 13-17
Configuring Loose Mode uRPF with the allow-default
Option
13-18