Cisco 10000-2P2-2DC - Page 621

Index
IN-25
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Configuring Loose Mode uRPF with the
allow-self-ping Option 13-17
Configuring Unicast RPF 13-13
Global Unicast RPF drops 13-14
interface type command 13-13
ip cef command 13-13
ip verify unicast source reachable-via any
command
13-13
Monitoring and Maintaining uRPF 13-14
Per-interface Unicast RPF drops 13-14
Prerequisites 13-12
Restrictions 13-12
show ip interface type command 13-14
show ip traffic command 13-14
show pxf cpu statistics drop interface command 13-14
user
restricting user access to network 5-33, 5-42
username command 9-4
utilization mark
high command 10-7
low command 10-7
V
VAI 5-23, 1-10
variable bit rate
definition 1-10
VBR
definition 1-10
VBR-nrt 1-10
vbr-nrt command 2-15, 8-3
VBR-nrt oversubscription 1-28, 8-14
VBR-rt 1-10
VCCI 22-20
VC class
applying to a range of PVCs 8-7
applying to individual PVC 8-7
applying to PVC within a PVC range 8-8
creating with autoprovisioning enabled 8-6
parameters 8-3
vc-class atm command 5-10, 8-6, 8-11
VCI 1-11
VCs
bandwidth reservation 8-14
definition of 1-11
oversubscription 8-14
VC scaling
ATM line cards
ATM PVC autoprovisioning 8-4
hierarchical shaping 2-8
VC weighting 1-28
vendor-specific
attributes 16-40
attribute screening 16-40
vendor-specific attributes
definition 1-11
dout-dialer 5-44
Service-Type 5-44
vpdn-vtemplate 5-44
virtual access interface
creating 5-23
virtual channel identifier
See VCI
virtual circuit
maximum VCs on ATM line cards 2-16, 8-16
See VC
virtual path identifier
See VPI
virtual path tunnels, maximum VCs on ATM line
cards
2-16, 8-16
virtual private dial network 22-18
See VPDN
virtual private network
See VPN
virtual routing and forwarding
See VRF
virtual routing and forwarding, See VRF
virtual-template command 3-21, 5-30, 6-3, 6-9