Cisco 15216 EDFA2 User Manual

CHAPTER
FINAL DRAFT - CISCO CONFIDENTIAL
4-1
Cisco ONS 15216 EDFA2 Operations Guide
78-16033-01
4
Provisioning Using ASH and SNMP
This chapter discusses the provisioning procedures for the Cisco ONS 15216 EDFA2 using SNMP and
a proprietary command line interface named the ASH shell. See Chapter 8, “Provisioning Using TL1”
for provisioning information using TL1 commands in the TL1 shell.
The provisioning procedure for the ONS 15216 EDFA2 in the ASH shell is as follows:
1. Log In via RS-232 (EIA/TIA-232) Port Using HyperTerminal, page 4-1
2. Set IP Address, page 4-3
3. Log In via LAN Port Using Telnet (Optional), page 4-3
4. Set Date and Time, page 4-4
5. Set Power Bus Mode (Simplex or Duplex), page 4-4
6. Verify Amplifier Operational Status, page 4-4
7. Set Gain, page 4-5
8. Set Alarm Thresholds, page 4-5
9. Set Password, page 4-10
10. Add Users, page 4-11
11. Save Changes, page 4-11
12. Log Off, page 4-12
13. Back Up System Configuration, page 4-12
14. Restore System Configuration, page 4-13
15. Recover Default Password, page 4-14
The following sections describe these steps in detail.
4.1 Log In via RS-232 (EIA/TIA-232) Port Using HyperTerminal
Logging in through the RS-232 (EIA/TIA-232) port is required to set the ONS 15216 EDFA2 IP address
before there can be access via the LAN port. (See “Log In via LAN Port Using Telnet (Optional)” section
on page 4-3.)
Step 1 Connect to the RS-232 (EIA/TIA-232) port on the front panel. See “Serial Connection Procedure”
section on page 3-7 for line connection and HyperTerminal setup instructions.
Step 2 Open HyperTerminal. (HyperTerminal can be found in the Microsoft Windows Accessories menu.)

Cisco 15216 EDFA2 Specifications

General

Brand	Cisco
Model	15216 EDFA2
Category	Network Router
Language	English