FINAL DRAFT - CISCO CONFIDENTIAL
4-2
Cisco ONS 15216 EDFA2 Operations Guide
78-16033-01
Chapter 4 Provisioning Using ASH and SNMP
Log In via RS-232 (EIA/TIA-232) Port Using HyperTerminal
Step 3 If you see the login window shown in Example 4-1 on page 4-2, skip to Step 4.
By default the ONS 15216 EDFA2 is in TL1 shell, so this step may be required to proceed in ASH shell.
When in TL1 shell, the screen opens to a simple prompt (
sidtidname:ONS15216 EDFA2>). To change to
ASH shell, log in using the procedure in “Log In via RS-232 (EIA/TIA-232) Port Using HyperTerminal”
section on page 8-1, and then enter the following command at the sid/tid name prompt:
Welcome to ONS15216 EDFA2 Console (v2.3.0)
sidtidname:ONS15216 EDFA2> ED-NE-GEN:::123:::CLI=ASH;
Then enter the following command at the hostname prompt:
sidtidname:ONS15216 EDFA2> INIT-SYS::ALL:1234::1;
The ONS 15216 EDFA2 should log you off and then bring up the ASH shell login window.
Step 4 Check that the ONS 15216 EDFA2 login window appears as shown in Example 4-1.
Example 4-1 ASH Shell Login Window
-- LOGIN ---------------------------------------------------- sysname
ONS15216 EDFA2 Optical Amplifier
--------------------------------
Software Version 2.3.0
Copyright (c) 2000-2003 Cisco Systems, Inc.
Username: { }
Password: { }
[Login]
Step 5 Enter both a user name and password.
The default user name and password is CISCO15 with no password (press Enter).
Note For security reasons, it is recommended to change the password from its default value. See Set Password,
page 4-10 or Set Password, page 8-10.
Step 6 Press Enter when [Login] becomes highlighted. Example 4-2 displays the login response.
Example 4-2 ASH Shell Login Response
Welcome to ONS15216 EDFA2 Console (v2.3.0)
ash:hostname:ONS15216 EDFA2>
An EIA/TIA-232 link to the ONS 15216 EDFA2 is established. The user can now provision the
ONS 15216 EDFA2.
To Next Page
Loading...
Need help?
General
