Cisco 350 Series Administration Guide

Administration
Idle Session Timeout
80 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
6
Idle Session Timeout
The Idle Session Timeout configures the time intervals that the management sessions can
remain idle before they timeout and you must log in again to reestablish one of the following
sessions:
• HTTP Session Timeout
• HTTPS Session Timeout
• Console Session Timeout
• Telnet Session Timeout
• SSH Session Timeout
To set the idle session timeout for various types of sessions:
STEP 1 Click Administration > Idle Session Timeout.
STEP 2 Select the timeout for the each type of session from the corresponding list. The default timeout
value is 10 minutes.
STEP 3 Click Apply to set the configuration settings on the device.
Time Settings
See Administration: Time Settings.
System Log
This section describes the system logging, which enables the device to generate multiple
independent logs. Each log is a set of messages describing system events.
The device generates the following local logs:
• Log sent to the console interface.
• Log written into a cyclical list of logged events in the RAM and erased when the
device reboots.

Cisco 350 Series Specifications

General

Model	Cisco 350 Series
Category	Switch
Ports	8, 24, 48
PoE	Available on some models
Layer	Layer 2
Switching Capacity	Up to 104 Gbps
VLAN Support	Yes (up to 256 VLANs)
QoS	Yes
Management	Web, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Port Type	Gigabit Ethernet, Fast Ethernet (depending on model)