Cisco 350 Series Administration Guide

Smartport
Error Handling
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 203
11
changed unless Auto Smartport detects an attaching device with a different Smartport type. If
the Persistent status of an interface is disabled, the interface reverts to the default Smartport
type when the attaching device to it ages out, the interface goes down, or the device is
rebooted. Enabling Persistent status on an interface eliminates the device detection delay that
otherwise occurs.
NOTE The persistence of the Smartport types applied to the interfaces are effective between reboots
only if the running configuration with the Smartport type applied at the interfaces is saved to
the startup configuration file.
Error Handling
When a smart port macro fails to apply to an interface, you can examine the point of the failure
in the Interface Settings page and reset the port and reapply the macro after the error is
corrected from the Interface Settings page.
Default Configuration
Smartport is always available. By default, Auto Smartport is enabled by Auto Voice VLAN,
relies on both CDP and LLDP to detect attaching device's Smartport type, and detects
Smartport type IP phone, IP phone + Desktop, Switch, and Wireless Access Point.
See Voice VLAN for a description of the voice factory defaults.

Cisco 350 Series Specifications

General

Model	Cisco 350 Series
Category	Switch
Ports	8, 24, 48
PoE	Available on some models
Layer	Layer 2
Switching Capacity	Up to 104 Gbps
VLAN Support	Yes (up to 256 VLANs)
QoS	Yes
Management	Web, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Port Type	Gigabit Ethernet, Fast Ethernet (depending on model)