Cisco 350 Series Administration Guide

Multicast
IPv4 Multicast Configuration
270 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
15
STEP 8 For each interface, select its association type. The options are as follows:
• Static—Attaches the interface to the Multicast group as a static member.
• Dynamic—Attaches the interface to the Multicast group as a dynamic member.
• Forbidden—Specifies that this port is forbidden from joining this group on this VLAN.
• None—Indicates that the port is not currently a member of this Multicast group on this
VLAN. This is selected by default until Static or Forbidden is selected.
STEP 9 Click Apply. The Running Configuration file is updated.
IPv4 Multicast Configuration
The following pages configure IPv4 Multicast Configuration:
• IGMP Snooping
• IGMP Interface Settings
• IGMP VLAN Settings
•IGMP Proxy
IGMP Snooping
To support selective IPv4 Multicast forwarding, bridge Multicast filtering must be enabled (in
the Properties page), and IGMP Snooping must be enabled globally and for each relevant
VLAN in the IGMP Snooping page.

Cisco 350 Series Specifications

General

Model	Cisco 350 Series
Category	Switch
Ports	8, 24, 48
PoE	Available on some models
Layer	Layer 2
Switching Capacity	Up to 104 Gbps
VLAN Support	Yes (up to 256 VLANs)
QoS	Yes
Management	Web, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Port Type	Gigabit Ethernet, Fast Ethernet (depending on model)