Cisco 350 Series Administration Guide

VLAN Management
Regular VLANs
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 229
12
Configuration Guidelines
Note the following feature configuration guidelines:
• MSTP—All VLANs in a private VLAN must be assigned to the same MSTP instance.
• IP Source Guard—Binding an ACL on IP source guard ports with private VLAN is
not recommended due to the amount of TCAM resources needed.
Regular VLANs
This section describes the GUI pages used to configure various types of VLANs. This section
describes:
• Regular VLAN Overview
• VLAN Settings
• Interface Settings
• Port to VLAN
• Port VLAN Membership
• VLAN Translation
• GVRP Settings
• MAC-Based VLAN Group Overview
• Subnet-Based VLAN Groups Overview
• Protocol-Based VLAN Groups Overview
Regular VLAN Overview
VLAN Configuration Workflow
To configure VLANs:
STEP 1 Create the required VLANs as described in the VLAN Settings section.
STEP 2 Set the desired VLAN-related configuration for ports and enable QinQ on an interface as
described in the Interface Settings section.

Cisco 350 Series Specifications

General

Model	Cisco 350 Series
Category	Switch
Ports	8, 24, 48
PoE	Available on some models
Layer	Layer 2
Switching Capacity	Up to 104 Gbps
VLAN Support	Yes (up to 256 VLANs)
QoS	Yes
Management	Web, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Port Type	Gigabit Ethernet, Fast Ethernet (depending on model)