Cisco 350 Series Administration Guide

Managing MAC Address Tables
Static Addresses
258 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
14
Static Addresses
Static MAC addresses are assigned to a specific physical interface and VLAN on the device. If
that address is detected on another interface, it is ignored, and is not written to the address
table.
To define a static address:
STEP 1 Click MAC Address Tables > Static Addresses.
The Static Addresses page contains the currently defined static addresses.
STEP 2 Click Add.
STEP 3 Enter the parameters.
• VLAN ID—Select the VLAN ID for the port.
• MAC Address—Enter the interface MAC address.
• Interface—Select an interface (unit/slot, port, or LAG) for the entry.
• Status—Select how the entry is treated. The options are:
- Permanent—The system never removes this MAC address. If the static MAC
address is saved in the Startup Configuration, it is retained after rebooting.
- Delete on reset—The static MAC address is deleted when the device is reset.
- Delete on timeout—The MAC address is deleted when aging occurs.
- Secure—The MAC address is secure when the interface is in classic locked mode
(see Port Security).
STEP 4 Click Apply. A new entry appears in the table.

Cisco 350 Series Specifications

General

Model	Cisco 350 Series
Category	Switch
Ports	8, 24, 48
PoE	Available on some models
Layer	Layer 2
Switching Capacity	Up to 104 Gbps
VLAN Support	Yes (up to 256 VLANs)
QoS	Yes
Management	Web, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Port Type	Gigabit Ethernet, Fast Ethernet (depending on model)