Cisco 350 Series Administration Guide

Security: IPv6 First Hop Security
Default Settings and Configuration
455 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
26
STEP 4 Attach the policy to a VLAN, port or LAG using either the Policy Attachment (VLAN) or
Policy Attachment (Port) pages.
Neighbor Binding Work Flow
STEP 1 In the Neighbor Binding Settings page, enter the list of VLANs on which this feature is
enabled.
STEP 2 In this same page, set the global configuration values that are used if no values are set in a
policy.
STEP 3 If required, either configure a user-defined policy or add rules the default policies for the
feature.
STEP 4 Add any manual entries required in the Neighbor Binding Table page
STEP 5 Attach the policy to a VLAN, port or LAG using either the Policy Attachment (VLAN) or
Policy Attachment (Port) pages.
IPv6 Source Guard Work Flow
STEP 1 In the IPv6 Source Guard Settings page, enter the list of VLANs on which this feature is
enabled.
STEP 2 If required, either configure a user-defined policy or add rules to the default policies for the
feature.
STEP 3 Attach the policy to a VLAN, port or LAG using either the Policy Attachment (VLAN) or
Policy Attachment (Port) pages.
Default Settings and Configuration
If IPv6 First Hop Security is enabled on a VLAN, the switch traps the following messages by
default:
• Router Advertisement (RA) messages

Cisco 350 Series Specifications

General

Model	Cisco 350 Series
Category	Switch
Ports	8, 24, 48
PoE	Available on some models
Layer	Layer 2
Switching Capacity	Up to 104 Gbps
VLAN Support	Yes (up to 256 VLANs)
QoS	Yes
Management	Web, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Port Type	Gigabit Ethernet, Fast Ethernet (depending on model)