Cisco 350 Series Administration Guide

10
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 160
Port Management
This section describes port configuration, link aggregation, and the Green Ethernet feature.
It covers the following topics:
•Workflow
• Port Settings
• Error Recovery Settings
• Loopback Detection Settings
• Link Aggregation
• UDLD
•PoE
• Green Ethernet
Workflow
To configure ports, perform the following actions:
1. Configure port by using the Port Settings page.
2. Enable/disable the Link Aggregation Control (LAG) protocol, and configure the potential
member ports to the desired LAGs by using the LAG Management page. By default, all
LAGs are empty.
3. Configure the Ethernet parameters, such as speed and auto-negotiation for the LAGs by
using the LAG Settings page.
4. Configure the LACP parameters for the ports that are members or candidates of a dynamic
LAG by using the LACP page.
5. Configure Green Ethernet and 802.3 Energy Efficient Ethernet by using the Properties page.

Cisco 350 Series Specifications

General

Model	Cisco 350 Series
Category	Switch
Ports	8, 24, 48
PoE	Available on some models
Layer	Layer 2
Switching Capacity	Up to 104 Gbps
VLAN Support	Yes (up to 256 VLANs)
QoS	Yes
Management	Web, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Port Type	Gigabit Ethernet, Fast Ethernet (depending on model)