Cisco 350 Series Administration Guide

8
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 116
Administration: Stack Management
This section describes how stacks are managed. It covers the following topics:
NOTE Stacking is only supported on the SG350 (except for the Sx350) and SG550 family of devices.
•Overview
• Types of Units in Stack
• Stack Topology
• Unit ID Assignment
• Master Selection Process
• Stack Changes
• Unit Failure in Stack
• Software Auto Synchronization in Stack
• Stack Management
Overview
Devices can either function on their own, or they can be connected into a stack of devices in
various stacking modes (see Stack Unit Mode).
By default, a device is always stackable, but has no port configured as a stack port. All the
ports in the devices are configured as network ports by default. A device without any stack
port can be thought of as the master device in a stack of only itself or as a standalone device.
To stack two or more devices, configure the desired network ports as stack ports in the devices
and connect the devices with the resulting stack ports in a ring or chain topology.
The devices (units) in a stack are connected through stack ports. These devices are then
collectively managed as a single logical device. In some cases, stack ports can become
members in a stack of Link Aggregation Groups (LAGs) increasing the bandwidth of the stack
interfaces. See Stack Port Link Aggregation.

Cisco 350 Series Specifications

General

Model	Cisco 350 Series
Category	Switch
Ports	8, 24, 48
PoE	Available on some models
Layer	Layer 2
Switching Capacity	Up to 104 Gbps
VLAN Support	Yes (up to 256 VLANs)
QoS	Yes
Management	Web, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Port Type	Gigabit Ethernet, Fast Ethernet (depending on model)