EasyManuals Logo

Cisco 350 Series Administration Guide

Cisco 350 Series
762 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #624 background imageLoading...
Page #624 background image
Access Control
IPv4-based ACL Creation
404 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
22
- EIGRP—Enhanced Interior Gateway Routing Protocol
- OSPF—Open Shortest Path First
- IPIP—IP in IP
- PIM—Protocol Independent Multicast
- L2TP—Layer 2 Tunneling Protocol
- ISIS—IGP-specific protocol
- Protocol ID to Match—Instead of selecting the name, enter the protocol ID.
Source IP Address—Select Any if all source address are acceptable or User defined to
enter a source address or range of source addresses.
Source IP Address Value—Enter the IP address to which the source IP address is to be
matched.
Source IP Wildcard Mask—Enter the mask to define a range of IP addresses. Note that
this mask is different than in other uses, such as subnet mask. Here, setting a bit as 1
indicates don't care and 0 indicates to mask that value.
NOTE Given a mask of 0000 0000 0000 0000 0000 0000 1111 1111 (which means that
you match on the bits where there is 0 and don't match on the bits where there are 1's).
You need to translate the 1's to a decimal integer and you write 0 for each four zeros. In
this example since 1111 1111 = 255, the mask would be written: as 0.0.0.255.
Destination IP Address—Select Any if all destination address are acceptable or User
defined to enter a destination address or range of destination addresses.
Destination IP Address Value—Enter the IP address to which the destination IP
address is to be matched.
Destination IP Wildcard Mask—Enter the mask to define a range of IP addresses.
Source Port—Select one of the following:
- Any—Match to all source ports.
- Single from list—Select a single TCP/UDP source port to which packets are
matched. This field is active only if 800/6-TCP or 800/17-UDP is selected in the
Select from List drop-down menu.
- Single by number—Enter a single TCP/UDP source port to which packets are
matched. This field is active only if 800/6-TCP or 800/17-UDP is selected in the
Select from List drop-down menu.

Table of Contents

Other manuals for Cisco 350 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 350 Series and is the answer not in the manual?

Cisco 350 Series Specifications

General IconGeneral
ModelCisco 350 Series
CategorySwitch
Ports8, 24, 48
PoEAvailable on some models
LayerLayer 2
Switching CapacityUp to 104 Gbps
VLAN SupportYes (up to 256 VLANs)
QoSYes
ManagementWeb, CLI, SNMP
Security FeaturesACLs, 802.1X, Port Security
Jumbo Frame SupportYes
Power SupplyInternal
DimensionsVaries by model
WeightVaries by model
Operating Temperature0°C to 45°C (32°F to 113°F)
Storage Temperature-20°C to 70°C (-4°F to 158°F)
Humidity10% to 90% non-condensing
Port TypeGigabit Ethernet, Fast Ethernet (depending on model)

Related product manuals