Cisco 350 Series Administration Guide

Smart Network Application (SNA)
Right-Hand Information Panel
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 481
25
• Locate Device—This option is only available for SNA switches. Selecting this
action will make the physical LEDs of the device start flashing for 5 minutes. As this is
happening, a dialogue is displayed that notifies that the location feature is in progress,
and allows canceling this operation.
• Explore Connection—This option appears when a single connection is selected.
Selecting this action opens the connection explorer for the selected connection.
• Explore Client Group—This option appears when a client group is selected.
Selecting this action opens the client explorer, filtered by the type of device in the
client group.
• Delete—This option only appears when all the selected devices are offline devices.
Selecting this action deletes all the selected devices from the topology map.
Basic Information Block
The Basic Information block displays attributes of the selected single element (see tables
below for a full description). The block is not displayed when more than one entity is selected.
Some of the information is shown at all times, and some is shown only if the View All button
is clicked.
If no information is received on a certain parameter, that parameter is not displayed in the
Basic Information section.

Cisco 350 Series Specifications

General

Model	Cisco 350 Series
Category	Switch
Ports	8, 24, 48
PoE	Available on some models
Layer	Layer 2
Switching Capacity	Up to 104 Gbps
VLAN Support	Yes (up to 256 VLANs)
QoS	Yes
Management	Web, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Port Type	Gigabit Ethernet, Fast Ethernet (depending on model)