EasyManuals Logo

Cisco 3925 User Manual

Cisco 3925
408 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #247 background imageLoading...
Page #247 background image
239
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Chapter Upgrading the Cisco IOS Software
How to Upgrade the IOS Image on the Access Point
Router# copy flash0: tftp:
IP address of remote host [255.255.255.255]? 192.0.0.1
filename to write on tftp host? c2900-universalk9-mz
writing c2900-mz !!!!...
successful ftp write.
How to Upgrade the IOS Image on the Access Point
This section describes how to upgrade the Cisco IOS image on the access point.
To upgrade the IOS image on the access point, establish connectivity between the access point and the
download server by following these steps:
Define the WAN Interface on the Router, page 239
Secure an IP Address on the Access Point, page 240
Confirm Connectivity and Settings, page 240
Upgrading the IOS Image on the Access Point, page 241
Define the WAN Interface on the Router
To define a WAN interface to connect to a TFTP network for image download, follow these steps,
beginning in global configuration mode.
SUMMARY STEPS
1. interface gigabitethernet slot/port
2. ip address ip-address mask
3. no shutdown
4. exit
DETAILED STEPS
Command Purpose
Step 1
interface gigabitethernet slot/port
Example:
Router(config)# interface gigabitethernet 0/0
Router(config-if)#
Enters the configuration mode for a Gigabit
Ethernet interface on the router.
Step 2
ip address ip-address mask
Example:
Router(config-if)# ip address 192.168.12.2
255.255.255.0
Router(config-if)#
Sets the IP address and subnet mask for the
specified Gigabit Ethernet interface.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 3925 and is the answer not in the manual?

Cisco 3925 Specifications

General IconGeneral
Product TypeRouter
Form FactorRack-mountable
Data Link ProtocolEthernet, Fast Ethernet, Gigabit Ethernet
Connectivity TechnologyWired
PowerAC 120/230 V (50/60 Hz)
Redundant Power SupplyOptional
Routing ProtocolOSPF, IS-IS, BGP, EIGRP, PIM
Network/Transport ProtocolIPSec
Remote Management ProtocolSNMP, Telnet, SSH, HTTP
Encryption AlgorithmDES, Triple DES, AES
Flash Memory256 MB
Weight11.5 kg
Interfaces2 x SFP (mini-GBIC)
Power SourceInternal power supply
Authentication MethodRADIUS, TACACS+, LDAP
Compliant StandardsIEEE 802.1Q, IEEE 802.3af
Operating Temperature0 to 40 °C
Operating Humidity5% to 85% (non-condensing)
Dimensions (WxDxH)44.5 x 47.2 x 8.9 cm

Related product manuals