Cisco 3925 User Manual

61
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Configuring Ethernet Virtual Connection Bridge
Domain
Ethernet virtual connection (EVC) infrastructure is a Layer 2 platform-independent bridging
architecture that supports Ethernet services. This chapter provides procedures for configuring EVC
Bridge Domain (BD) and the features it supports on the Cisco Integrated Services Routers (ISR) G2.
• Configuring EVCs on Cisco ISR G2 Router, page 61
• Ethernet Data Plane Loopback, page 64
• Connectivity Fault Management (CFM) over EVC BD, page 68
• Support for Y.1731 Performance Monitoring for EVC BD, page 87
• Support for Switch Virtual Interfaces (SVI) on ISR G2 Metro Ethernet BD, page 90
• EVC Quality of Service (QoS), page 92
Configuring EVCs on Cisco ISR G2 Router
Configuring an EFP and a BD on the Cisco ISR G2 Router
Configuring a service instance on a Layer 2 port creates an EFP on which you can configure EVC
features.
Note • You cannot use the same VLAN ID for encapsulating on a Layer 3 sub-interface and an EFP (service
instance) on a WAN interface.
• If there is a sub-interface and service-instance both configured on a WAN interface for untagged
traffic, then the traffic will always go to the main interface and the service-instance with untagged
traffic will not work.
Perform this task to configure an EFP.
SUMMARY STEPS
Step 1 enable
Step 2 configure terminal

Cisco 3925 Specifications

General

Product Type	Router
Form Factor	Rack-mountable
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Connectivity Technology	Wired
Power	AC 120/230 V (50/60 Hz)
Redundant Power Supply	Optional
Routing Protocol	OSPF, IS-IS, BGP, EIGRP, PIM
Network/Transport Protocol	IPSec
Remote Management Protocol	SNMP, Telnet, SSH, HTTP
Encryption Algorithm	DES, Triple DES, AES
Flash Memory	256 MB
Weight	11.5 kg
Interfaces	2 x SFP (mini-GBIC)
Power Source	Internal power supply
Authentication Method	RADIUS, TACACS+, LDAP
Compliant Standards	IEEE 802.1Q, IEEE 802.3af
Operating Temperature	0 to 40 °C
Operating Humidity	5% to 85% (non-condensing)
Dimensions (WxDxH)	44.5 x 47.2 x 8.9 cm