EasyManuals Logo

Cisco 3925 User Manual

Cisco 3925
408 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #249 background imageLoading...
Page #249 background image
241
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Chapter Upgrading the Cisco IOS Software
How to Upgrade the IOS Image on the Access Point
description Service module interface to manage the embedded AP
ip address 10.0.0.1 255.0.0.0
arp timeout 0
!
interface GigabitEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Vlan1
ip address 192.168.10.1 255.255.255.0
!
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/0
!
no ip http server
Upgrading the IOS Image on the Access Point
Follow the image upgrade instructions at Cisco.com using the IOS CLI,
http://www.cisco.com/en/US/docs/wireless/access_point/12.3_8_JA/configuration/guide/
s38mfw.html#wp1035609.
Note If the access point enters Bootloader mode, manually configure the IP address, default router, netmask,
and default gateway to upgrade the IOS image.
Note The IP address must be assigned to the same subnet as the VLAN1 interface on the router. Here is an
example configuration.
Example
ap: set
CONTROLLER_TYPE=0x05A4
DEFAULT_ROUTER=192.168.10.1
ENABLE_BREAK=yes
IOS_STATIC_DEFAULT_GATEWAY=192.168.10.1
IP_ADDR=192.168.10.2
MANUAL_BOOT=yes
NETMASK=255.255.255.0
PEP_PRODUCT_ID=AP801AGN-A-K9
PRODUCT_MODEL_NUM=AP801AGN-A-K9
TOP_ASSY_SERIAL_NUM=FHKTESTTEST
ap: copy tftp://223.255.254.254/saek/ap801-k9w7-tar.124-10b.JDA flash0:
ap801-k9w7-tar.124-10b.JDA

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 3925 and is the answer not in the manual?

Cisco 3925 Specifications

General IconGeneral
Product TypeRouter
Form FactorRack-mountable
Data Link ProtocolEthernet, Fast Ethernet, Gigabit Ethernet
Connectivity TechnologyWired
PowerAC 120/230 V (50/60 Hz)
Redundant Power SupplyOptional
Routing ProtocolOSPF, IS-IS, BGP, EIGRP, PIM
Network/Transport ProtocolIPSec
Remote Management ProtocolSNMP, Telnet, SSH, HTTP
Encryption AlgorithmDES, Triple DES, AES
Flash Memory256 MB
Weight11.5 kg
Interfaces2 x SFP (mini-GBIC)
Power SourceInternal power supply
Authentication MethodRADIUS, TACACS+, LDAP
Compliant StandardsIEEE 802.1Q, IEEE 802.3af
Operating Temperature0 to 40 °C
Operating Humidity5% to 85% (non-condensing)
Dimensions (WxDxH)44.5 x 47.2 x 8.9 cm

Related product manuals