Cisco 3925 User Manual

247
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Configuring the Wireless Device
The following sections describe how to configure the wireless device on the Cisco 1941W integrated
services router (ISR):
• Starting a Wireless Configuration Session, page 247
• Configuring Wireless Settings, page 249
• Upgrading to Cisco Unified Software, page 255
• Related Documentation, page 258
Note You can upgrade the software on the device to Cisco Unified software. See the “Upgrading to Cisco
Unified Software” section on page 255.
Note The wireless device is embedded on the router and does not have an external console port for
connections. To configure the wireless device, use a console cable to connect a personal computer to the
host router’s Console serial port, and follow the instruction to establish a configuration session.
Starting a Wireless Configuration Session
Enter the following commands in global configuration mode on the router’s Cisco IOS command-line
interface (CLI).
SUMMARY STEPS
1. interface wlan-ap0
2. ip address subnet mask
3. no shut
4. interface vlan1
5. ip address subnet mask
6. exit
7. exit
8. service-module wlan-ap 0 session

Cisco 3925 Specifications

General

Product Type	Router
Form Factor	Rack-mountable
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Connectivity Technology	Wired
Power	AC 120/230 V (50/60 Hz)
Redundant Power Supply	Optional
Routing Protocol	OSPF, IS-IS, BGP, EIGRP, PIM
Network/Transport Protocol	IPSec
Remote Management Protocol	SNMP, Telnet, SSH, HTTP
Encryption Algorithm	DES, Triple DES, AES
Flash Memory	256 MB
Weight	11.5 kg
Interfaces	2 x SFP (mini-GBIC)
Power Source	Internal power supply
Authentication Method	RADIUS, TACACS+, LDAP
Compliant Standards	IEEE 802.1Q, IEEE 802.3af
Operating Temperature	0 to 40 °C
Operating Humidity	5% to 85% (non-condensing)
Dimensions (WxDxH)	44.5 x 47.2 x 8.9 cm