EasyManuals Logo

Cisco 3925 User Manual

Cisco 3925
408 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #256 background imageLoading...
Page #256 background image
248
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Chapter Configuring the Wireless Device
Starting a Wireless Configuration Session
DETAILED STEPS
Command Purpose
Step 1
interface wlan-ap0
Example:
router(config)# interface wlan-ap0
router(config-if)#
Defines the router’s console interface to the
wireless device. It is used for communication
between the router’s Console and the wireless
device.
Always use port 0.
The following message appears:
The wlan-ap 0 interface is used for
managing the embedded AP. Please use the
service-module wlan-ap 0 session command to
console into the embedded AP.
Step 2
ip address subnet mask
Example:
router(config-if)# ip address
10.21.0.20 255.255.255.0
Example:
router(config-if)# ip unnumbered vlan1
Specifies the interface IP address and subnet
mask.
Note The IP address can be shared with the IP
address assigned to the Cisco Integrated
Services Router by using the ip
unnumbered vlan1 command.
Step 3
no shut
Example:
router(config-if)# no shut
Specifies the internal interface connection
remains open.
Step 4
interface vlan1
Example:
router(config-if)# interface vlan1
Specifies the virtual LAN interface for data
communication on the internal GE0
1
port to other
interfaces.
Step 5
ip address subnet mask
Example:
router(config-if)# ip address
10.10.0.30 255.255.255.0
Specifies the interface IP address and subnet
mask.
Step 6
exit
Example:
router(config-if)# exit
router(config)#
Exits the mode.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 3925 and is the answer not in the manual?

Cisco 3925 Specifications

General IconGeneral
Product TypeRouter
Form FactorRack-mountable
Data Link ProtocolEthernet, Fast Ethernet, Gigabit Ethernet
Connectivity TechnologyWired
PowerAC 120/230 V (50/60 Hz)
Redundant Power SupplyOptional
Routing ProtocolOSPF, IS-IS, BGP, EIGRP, PIM
Network/Transport ProtocolIPSec
Remote Management ProtocolSNMP, Telnet, SSH, HTTP
Encryption AlgorithmDES, Triple DES, AES
Flash Memory256 MB
Weight11.5 kg
Interfaces2 x SFP (mini-GBIC)
Power SourceInternal power supply
Authentication MethodRADIUS, TACACS+, LDAP
Compliant StandardsIEEE 802.1Q, IEEE 802.3af
Operating Temperature0 to 40 °C
Operating Humidity5% to 85% (non-condensing)
Dimensions (WxDxH)44.5 x 47.2 x 8.9 cm

Related product manuals