Management Port
The Secure Firewall 4200 chassis management port is a 1/10/25-Gb SFP port that supports fiber as well
as DAC or GLC-TE.
RJ-45 Console Port
The Secure Firewall 4200 does not ship with an RJ-45 serial cable unless you order it with the chassis.
You can obtain a cable, for example, a USB-to-RJ-45 serial cable. You can use the CLI to configure
your 4200 through the RJ-45 serial console port by using a terminal server or a terminal emulation
program on a computer.
The RJ-45 (8P8C) port supports RS-232 signaling to an internal UART controller. The console port does
not have any hardware flow control, and does not support a remote dial-in modem. The default console
port settings are displayed as follows:
• 9,600 bits per second
• 8 data bits
• No parity
• 1 stop bit
• No flow control
Type A USB 3.0 Port
You can use the external Type A USB port to attach a data-storage device. The external USB drive
identifier is usb:. The Type A USB port supports the following:
• Hot swapping
• USB drive formatted with FAT32
• Boot kickstart image from ROMMON for discovery recovery purposes
• Copy files to and from workspace:/ and volatile:/ within local-mgmt. The most relevant files are:
• Core files
• Ethanalyzer packet captures
• Tech-support files
• Security module log files
• Platform bundle image upload using download image usbA:
The Type A USB port does not support Cisco Secure Package (CSP) image upload support.
Network Ports
The Secure Firewall 4200 chassis has two network module slots that support the following network
modules:
• 4-port 40-Gb QSFP/QSFP+ (FPR-X-NM-4X40G)
• 4-port 40/100/200-Gb QSFP28/QSFP (FPR-X-NM-4X200G)
• 2-port 100-Gb QSFP56/QSFP28/QSFP (FPR-X-NM-2X100G)
Cisco Secure Firewall 4200 Series Hardware Installation Guide
10
Overview
Front Panel
To Next Page
Loading...
Need help?
General
