Index
IN-5
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
OL-2239-02
I
IGRP (Interior Gateway Routing Protocol)
authentication 1-84
IGRP (Internet Gateway Routing Protocol)
IP Enhanced IGRP Route Authentication 1-84
IP routing with 2-20
input power level, upstream 3-24
insertion interval, cable modem 5-6
Intercept
COPS Intercept 1-72
COPS TCP Support 1-74
Service Independent Intercept 1-78
Interior Gateway Routing Protocol
See IGRP
interleave depth, downstream 3-8
IP
broadcast echo 1-79, 3-34
Easy IP (phase 1) 1-83
IP broadcast echo 3-34
IP enhanced IGRP route authentication 1-84
IP multicast echo 3-33
IP parameters, setting optional 3-33
IP routing features supported on Cisco uBR7200
series
1-80
IP type-of-service and precedence for GRE
tunnels
1-127
multicast echo 3-34
Network Address Translation (NAT) 1-84
setting routing protocols for 2-20
IPv6 over L2VPN 1-127
K
key encryption key (KEK) 2-30
M
MAC (Media Access Control)
configuring PHS 3-33
Management Information Base (MIB) Changes and
Enhancements
1-91
minislot 3-25
modem
see cable modem
modulation, downstream 3-8
MPEG, downstream framing format 3-9, 3-10
multicast echo 3-33, 3-34
multicast options 1-96
Multilink Point-to-Point Protocol (MLPPP) 1-134
N
NAT (Network Address Translation) 1-84
Network-Based Application Recognition (NBAR) 1-46
Network Time Protocol (NTP) 1-116
numbering
cable interface line card slot 1-15
logical interface 1-15
port adapter slot 1-15
NVRAM (Nonvolatile Random-Access Memory), saving
and viewing contents in
2-29
P
Packet Cable 1-101
packet interception 3-29
Parser Cache 1-34
parser cache command 1-34
password 2-6
passwords
password recovery process 2-7
setting password protection 2-5
PHS (Payload Header Suppression)
configuring 3-33
overview 1-62
ping docsis command 8-10
port adapters
To Next Page
Loading...
Need help?
General
