Intercom
46 System Telephone Features Cisco 7960/7940 Telephone User Guide
620-05600070B
Parking a Call
Press the Indicated Call Park softkey or button.
Retrieving a Parked Call
To retrieve a call parked using Indicated Call Park, do one of the following:
• Press an Indicated Call Park softkey or button for the same Indicated Call
Park line that was used to park the call. (i.e., if the call was parked using
ICPark 5100, press an ICPark 5100 softkey or button on any phone to be
connected to the parked call)
• Dial the Indicated Call Park line number from any phone. (i.e.if the call
was parked using ICPark 5100, dial 5100 from any phone to be
connected to the parked call)
Intercom
Use this feature to make and receive extension-to-extension intercom calls.
Making an Intercom Call
1. With the 7960 MGCP off-hook, press the more soft key.
2. Press the Intercom (Intcom) soft key.
3. After hearing the dial tone, dial the desired 4-digit extension number.
The system identifies the call to the called party as an intercom call by play-
ing a beep and turning on the called party’s speakerphone so that you can
begin speaking with each other immediately.
NOTE: If the called party has the Do Not Disturb feature active, or if they are already off-
hook, you get a busy tone when attempting to call them using the intercom
feature.
Receiving an Intercom Call
Incoming Intercom calls are announced by a brief dial-tone followed by the
intercom tones. A tone is played every 60 seconds during active intercom calls.
Notes on Intercom Calls
• Intercom calls are announced by a brief dial-tone followed by the intercom
tones. A tone is played every 60 seconds during active intercom calls
(except for MGCP phones).
To Next Page
Loading...
Need help?
General
