Joining a Meet-Me Conference
Cisco 7960/7940 Telephone User Guide System Telephone Features 49
620-05600070B
Silencing Announcements
You may not wish to hear the repeating announcements that “you are the first
caller” or “the conference will start soon”. Dialing #2 will toggle the current
announcement with silence.
To disable the announcement or revert to the announcement, press #2.
Silence will end under the following conditions:
When... And if... Then
You dial #2. N/A You hear the
announcement that was
playing at time silence was
started
The conference
reservation state changes
from Starts Soon to Active.
You are the only caller
connected to the
conference.
You hear the First Caller
announcement.
The conference
reservation state changes
from Starts Soon to Active.
There are additional callers
connected to the
conference.
You are connected to the
conference.
The conference
reservation state changes
from Active to Ends Soon.
You are the moderator and
only caller connected to the
conference.
You hear the Ends Soon
announcement.
Another participant joins
the conference.
You were listening to the
First Caller announcement
when silence was started.
You will be connected to
the conference.
You are the moderator. You perform any floor
control operation.
You will be prompted with
the appropriate
announcement and
connected to the
appropriate announcement
based on the conference
state.
The Start Soon
announcement was playing
when silence was started.
The moderator mutes or
unmutes you.
You will hear the Starts
Soon announcement.
The conference bridge
state changes for some
reason.
N/A You will hear the Starts
Soon, First Caller or Ends
Soon announcement
depending on the
conference reservation
state.
To Next Page
Loading...
Need help?
General
