CHAPTER
4-1
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
OL-16215-12
4
Initial Configuration
This chapter provides instructions for initial configuration of the Cisco 860 series, 880 series, and 890
series Integrated Services Routers (ISRs). For the initial configuration, we recommend using
Cisco Configuration Professional (CP) Express. Cisco CP Express is a web-based graphical user
interface that guides you through initial configuration.
You may also initially configure your router by using the Cisco IOS command-line interface (CLI) or by
using the setup command facility. To create the initial configuration, the setup command facility prompts
you for basic information about your router and network.
This chapter contains the following sections:
• Cisco Configuration Professional Express, page 4-1
• Cisco IOS CLI, page 4-1
• Setup Command Facility, page 4-3
• Verifying the Initial Configuration, page 4-5
• Initial Configuration of the Wireless Access Point, page 4-6
Note Some SKUs may not include a default configuration file. If your router does not have a default
configuration file, go to the “Setup Command Facility” section on page 3 to configure the initial router
settings.
Cisco Configuration Professional Express
After you connect the cables and power up the router, we recommend that you use the Cisco CP Express
web-based application to configure the initial router settings.
For instructions on how to use Cisco CP Express to configure the router see Cisco CP Express User’s
Guide.
Cisco IOS CLI
To configure the initial router settings by using the Cisco IOS CLI, you must set up a console connection.
For instructions on how to set up a console connection, see the “Connecting a Terminal or PC to the
Console Port” section on page 3-9.
To Next Page
Loading...
Need help?
General
