DescriptionParameter
Format of LDAP results displayed on phone, where:
• a—Attribute name
• cn—Common name
• sn—Surname (last name)
• telephoneNumber—Phone number
• n—Display name
For example, n=Phone causes “Phone:” to be displayed in front
of the phone number of an LDAP query result when the detail
soft button is pressed.
• t—type
When t=p, that is, t is of type phone number, the retrieved number
can be dialed. Only one number can be made dialable. If two
numbers are defined as dialable, only the first number is used.
For example, a=ipPhone, t=p; a=mobile, t=p;
This example results in only the IP Phone number being dialable
and the mobile number is ignored.
• p—phone number
When p is assigned to a type attribute, example t=p, the retrieved
number is dialable by the phone.
For example,
a=givenName,n=firstname;a=sn,n=lastname;a=cn,n=cn;a=telephoneNumber,n=tele,t=p
Default: Blank
Display Attrs
Can be blank if not needed.
With the LDAP number mapping, you can manipulate
the number that was retrieved from the LDAP server.
For example, you can append 9 to the number if your
dial plan requires a user to enter 9 before dialing. Add
the 9 prefix by adding (<:9xx.>) to the LDAP Number
Mapping field. For example, 555 1212 would become
9555 1212.
Note
If you do not manipulate the number in this fashion, a user can
use the Edit Dial feature to edit the number before dialing out.
Default: Blank
Number Mapping
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
276
Cisco IP Phone Troubleshooting
LDAP
To Next Page
Loading...
Need help?
General
