Cisco Aironet 1300 Series - Enabling the Radio Interfaces

Contents
v
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-02
CHAPTER 5 Configuring the Access Point/Bridge for the First Time 5-1
Before You Start 5-2
Resetting the Access Point/Bridge to Default Settings 5-2
Default IP Address Behavior 5-2
Default SSID and Default Role 5-3
Obtaining and Assigning an IP Address 5-3
Connecting to the Access Point/Bridge Locally 5-3
Using the Power Injector’s Ethernet Port 5-3
Using the Power Injector’s Console Port 5-4
Assigning Basic Settings 5-4
Default Settings on the Express Setup Page 5-8
Enabling the Radio Interfaces 5-9
Adjusting Output Power Level 5-9
Configuring Basic Security Settings 5-9
Understanding Express Security Settings 5-11
Using VLANs 5-11
Express Security Types 5-11
Express Security Limitations 5-12
Using the Express Security Page 5-13
Finding the IP Address Using the CLI 5-13
Assigning an IP Address Using the CLI 5-14
Using a Telnet Session to Access the CLI 5-14
CHAPTER 6 Using the Command-Line Interface 6-1
Connecting to the Console Serial Port 6-2
Using a Telnet Session to Open the CLI 6-3
Using Secure Shell to Open the CLI 6-3
IOS Command Modes 6-4
Getting Help 6-5
Abbreviating Commands 6-5
Using no and default Forms of Commands 6-5
Understanding CLI Messages 6-6
Using Command History 6-6
Changing the Command History Buffer Size 6-7
Recalling Commands 6-7
Disabling the Command History Feature 6-7
Using Editing Features 6-8