Configure ICSR Switchover Guard Timer 228
Enable BFD Multihop Fall-over 229
ip route Command 229
ip routev6 Command 230
Adjust BFD Interval 230
Enable Advertising BGP Routes from Standby ICSR Chassis 230
Saving the Configuration 230
BFD Support for Link Aggregation Member Links 230
Overview 231
Configuring Support for BFD Linkagg Member-links 231
Saving the Configuration 232
Viewing Routing Information 232
CHAPTER 21
VLANs 235
Overview 235
Overlapping IP Address Pool Support – GGSN 235
RADIUS VLAN Support – Enhanced Charging Services 236
APN Support – PDN Gateway (P-GW) 236
Creating VLAN Tags 236
Verifying the Port Configuration 237
Configuring Subscriber VLAN Associations 238
RADIUS Attributes Used 238
Configuring Local Subscriber Profiles 238
Verify the Subscriber Profile Configuration 238
VLAN-Related CLI Commands 239
CHAPTER 22
BGP MPLS VPNs 241
Introduction 241
MPLS-CE Connected to PE 242
as a PE 242
Overview 242
Sample Configuration 243
IPv6 Support for BGP MPLS VPNs 244
Overview 244
Sample Configuration 244
ASR 5500 System Administration Guide, StarOS Release 21.5
xvi
Contents
To Next Page
Loading...
