CHAPTER 3
System Settings
This chapter provides instructions for configuring the following StarOS options.
It is assumed that the procedures to initially configure the system as described in Getting Started have been
completed.
The commands used in the configuration examples in this section are the most likely-used commands
and/or keyword options. In many cases, other optional commands and/or keyword options are available.
Refer to the Command Line Interface Reference for complete information.
Important
•
Configuring System Timing, page 25
•
Configuring SF Boot Configuration Pause, page 29
•
Enabling CLI Timestamping, page 30
•
Configuring CLI Confirmation Prompts, page 30
•
Configuring System Administrative Users, page 32
•
Configuring TACACS+ for System Administrative Users, page 40
•
Separating Authentication Methods, page 44
•
Configuring a Chassis Key, page 46
•
Enabling Automatic Reset of FSC Fabric, page 48
Configuring System Timing
The system is equipped with a clock that supplies the timestamp for statistical counters, accounting records,
logging, and event notification. After the initial configuration of the system clock, you can configure the
system to communicate with one or more Network Time Protocol (NTP) server(s) to ensure that the clock is
always accurate.
In addition to configuring the timing source, you must configure the system's time zone.
ASR 5500 System Administration Guide, StarOS Release 21.5
25
To Next Page
Loading...
Need help?
General
