Cisco ASR 5500 System Administration Guide

no shutdown
bind interface interface_name context_name
end
Notes:
•
Optional: Configure VLAN-subscriber associations. Refer to Configuring Subscriber VLAN Associations,
on page 238 for more information.
•
Repeat this procedure as needed to configure additional VLANs for the port.
•
Refer to VLAN-Related CLI Commands , on page 239 and the Command Line Interface Reference for
additional information.
•
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Verifying the Port Configuration
Run the following command to verify the port configuration:
[local]host_name# show port info slot/port
An example of this command's output when at least one VLAN has been configured for the port is shown
below:
Port: 5/11
Port Type : 10G Ethernet
Role : Service Port
Description : (None Set)
Redundancy Mode : Port Mode
Redundant With : 6/11
Preferred Port : Non-Revertive
Physical ifIndex : 85262336
Administrative State : Enabled
Configured Duplex : Auto
Configured Speed : Auto
Fault Unidirection Mode : 802_3ae clause 46
Configured Flow Control : Enabled
Interface MAC Address : 64-9E-F3-69-5B-EA
SRP Virtual MAC Address : None
Fixed MAC Address : 64-9E-F3-69-5B-CA
Link State : Up
Link Duplex : Full
Link Speed : 10 Gb
Flow Control : Enabled
Link Aggregation Group : None
Untagged:
Logical ifIndex : 85262337
Operational State : Up, Active
Tagged VLAN: VID 10
Logical ifIndex : 285278210
VLAN Type : Standard
VLAN Priority : 0
Administrative State : Enabled
Operational State : Up, Active
Number of VLANs : 1
SFP Module : Present (10G Base-SR)
Notes:
•
Repeat this sequence as needed to verify additional ports.
•
Optional: Configure VLAN-subscriber associations. Refer to Configuring Subscriber VLAN Associations,
on page 238 for more information.
ASR 5500 System Administration Guide, StarOS Release 21.5
237
VLANs
Verifying the Port Configuration

Cisco ASR 5500 Specifications

General

Brand	Cisco
Model	ASR 5500
Category	Network Router
Language	English