Cisco ASR 5500 - Recovery Control Task Statistics; Show Rct Stats Command

SMGR_STATE_CONNECTED SMGR_EVT_AUTH_SUCCESS
SMGR_STATE_CONNECTED SMGR_EVT_AUTH_REQ
SMGR_STATE_CONNECTED SMGR_EVT_AUTH_SUCCESS
SMGR_STATE_CONNECTED SMGR_EVT_AUTH_REQ
SMGR_STATE_CONNECTED SMGR_EVT_AUTH_SUCCESS
SMGR_STATE_CONNECTED SMGR_EVT_AUTH_REQ
SMGR_STATE_CONNECTED SMGR_EVT_AUTH_SUCCESS
Data Reorder statistics
Total timer expiry: 0 Total flush (tmr expiry): 0
Total no buffers: 0 Total flush (no buffers): 0
Total flush (queue full): 0 Total flush (out of range):0
Total flush (svc change): 0 Total out-of-seq pkt drop: 0
Total out-of-seq arrived: 0
IPv4 Reassembly Statistics:
Success: 0 In Progress: 0
Failure (timeout): 0 Failure (no buffers): 0
Failure (other reasons): 0
Redirected Session Entries:
Allowed: 2000 Current: 0
Added: Deleted: 0
Revoked for use by different subscriber: 0
Recovery Control Task Statistics
Recovery Control Task (RCT) statistics show the following:
• Recovery action taken – Migration, Shutdown, Switchover
• Type of event – Planned or Unplanned
• From card to card – slot numbers
• Start time – YYYY-MMM-DD+hh:mm:sss.sss
• Duration – seconds
•
Card failure device (such as CPUn)
•
Card failure reason
•
Card is in usable state or not failed
• Recovery action status – Success or failure reason
•
If recovery action failed, failure time stamp
•
If recovery action failed, failure task facility name
•
If recovery action failed, failure instance number
show rct stats Command
The Exec mode show rct stats command employs the following syntax:
[local]host_name# show rct stats [verbose]
Without the verbose keyword, a summary output is displayed as show in the example below:
RCT stats details (Last 1 Actions)
# Action Type From To Start Time Duration Status
--- ------------- --------- ---- ---- ------------------------ ---------- -------
ASR 5500 System Administration Guide, StarOS Release 21.5
263
Session Recovery
Recovery Control Task Statistics