Cisco ASR 907 Installing

Installing the Interface Module Carrier
It is recommended that you always install the IM carrier (A9XX-2IMA-CARRIER) in the lower slot before
installing the carrier in the upper slot.
Note
Procedure
Step 1 Before inserting an IM carrier, make sure that the chassis is grounded.
Step 2 To insert the IM carrier, carefully align the edges of the IM carrier between the upper and lower edges of the
router slot.
Step 3 Carefully slide the IM carrier into the router slot until the IM carrier makes contact with the backplane. See
the figure below.
Figure 22: Installing the IM Carrier
Interface Module Installation
The following sections describe the various tasks of associated with interface module installation on the Cisco
ASR 907 Router:
Installing the Cisco ASR 907 Router
24
Installing the Cisco ASR 907 Router
Installing the Interface Module Carrier

Cisco ASR 907 Specifications

General

Model	ASR 907
Product Series	ASR 900
Product Type	Router
Rack-mountable	Yes
Rack Height	1RU
Port Density	Varies by configuration
Interfaces/Ports	Gigabit Ethernet, 10 Gigabit Ethernet
Power Supply	Dual AC or DC
Operating System	Cisco IOS XE
Redundancy	Power supply redundancy, Fan redundancy
Management Interfaces	Console
Supported Protocols	BGP, OSPF, EIGRP, IS-IS, MPLS
Operating Temperature	0 to 40 °C
Storage Temperature	-40 to 70°C (-40 to 158°F)
Environmental Conditions	Humidity: 5 to 95% relative humidity, noncondensing
Ports	Varies by configuration