DescriptionPID
Power Cord for AC V2 Power Module (Australia), AS 3112PWR-CAB-AC-AUS
Power Cord for AC V2 Power Module (Europe), CEE 7/7PWR-CAB-AC-EU
Power Cord for AC V2 Power Module (Italy), CEI-23-50PWR-CAB-AC-ITA
Power Cord for AC V2 Power Module (South Africa), SABS 164PWR-CAB-AC-SA
Power Cord for AC V2 Power Module (UK), EN 60309-2PWR-CAB-AC-UK
Power Cord for AC V2 Power Module (Israel), SI 32PWR-CAB-AC-ISRL
Power Cord for AC V2 Power Module (China), GB2099.1/GB1002PWR-CAB-AC-CHN
Power Cord for AC V2 Power Module (Brazil), NBR 14136PWR-CAB-AC-BRA
Power Cord for AC V2 Power Module (Swiss), SEV 1011PWR-CAB-AC-SUI
Power Cord for AC V2 Power Module (Japan), JIS C8303PWR-CAB-AC-JPN
India AC Power Cord for Cisco ASR 900, IS:1293PWR-CAB-AC-IND
AC POWER CORD, WIRE HARNESS, Argentina, IRAM 2073, IEC60320
C21, ST, 4M, 30 AWG, STRANDED, 250.0 V, 16.0 A
PWR-CAB-AC-ARG
Activating the AC Power Supply
Follow these steps to activate the AC power supply:
Procedure
Step 1 Plug the power cord into the power supply.
Step 2 Connect the other end of the power cord to an AC-input power source.
Step 3 Verify power supply operation by checking that the power supply LEDs are in the following states:
• INPUT OK LED is green
• OUTPUT FAIL LED is green
Step 4 If the LEDs indicate a power problem, see the Troubleshooting for troubleshooting information.
Step 5 If you are installing a redundant power supply, repeat these steps for the second power source.
If you are installing a redundant AC power supply, ensure that each power supply is connected to
a separate power source in order to prevent power loss in the event of a power failure.
Note
Removing and Replacing the AC Power Supply
This section describes how to remove and replace the AC power supply.
Installing the Cisco ASR 907 Router
37
Installing the Cisco ASR 907 Router
Activating the AC Power Supply
To Next Page
Loading...
Need help?
General
