Cisco Catalyst 250 Series Command Reference

debug platform etherchannel
To enable debugging of platform-dependent EtherChannel events, use the debug platform etherchannel
command in EXEC mode. To disable debugging, use the no form of this command.
debug platform etherchannel{init| link-up| rpc| warnings}
no debug platform etherchannel {init| link-up| rpc| warnings}
Syntax Description
Displays EtherChannel module initialization debug messages.init
Displays EtherChannel link-up and link-down related debug messages.link-up
Displays EtherChannel remote procedure call (RPC) debug messages.rpc
Displays EtherChannel warning debug messages.warnings
Command Default
Debugging is disabled.
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS 15.0(2)EX
Usage Guidelines
The undebug platform etherchannel command is the same as the no debug platform etherchannel command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable debugging
on a stack member, start a session from the stack master by using the session switch-number command in
privileged EXEC mode. Enter the debug command at the command-line prompt of the stack member.
To enable debugging on a stack member without first starting a session on the stack master, use the remote
command switch-number LINE command in privileged EXEC mode.
Examples
This example shows how to display debug messages related to Etherchannel initialization:
Switch# debug platform etherchannel init
Catalyst 2960-X Switch Layer 2 Command Reference, Cisco IOS Release 15.0(2)EX
34 OL-29043 -01
Layer 2 Commands
debug platform etherchannel

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English