Cisco Catalyst 250 Series Command Reference

show etherchannel
To display EtherChannel information for a channel, use the show etherchannel command in user EXEC
mode.
show etherchannel [channel-group-number | {detail | port | port-channel | protocol | summary }] | [detail|
port| port-channel| protocol| summary]
Syntax Description
(Optional) Channel group number. The range is 1 to 24.
channel-group-number
Displays detailed EtherChannel information.detail
Displays EtherChannel port information.port
Displays port-channel information.port-channel
Displays the protocol that is being used in the channel.protocol
Displays a one-line summary per channel group.summary
Displays the load-balance or frame-distribution scheme among ports in
the port channel.
load-balance
Command Default
None
Command Modes
User EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS 15.0(2)EX
Usage Guidelines
If you do not specify a channel group number, all channel groups are displayed.
Examples
This is an example of output from the show etherchannel channel-group-number detail command:
Switch> show etherchannel 1 detail
Group state = L2
Ports: 2 Maxports = 16
Port-channels: 1 Max Port-channels = 16
Protocol: LACP
Ports in the group:
-------------------
Port: Gi1/0/1
------------
Catalyst 2960-X Switch Layer 2 Command Reference, Cisco IOS Release 15.0(2)EX
OL-29043 -01 55
Layer 2 Commands
show etherchannel

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English