debug platform pm
To enable debugging of the platform-dependent port manager software module, use the debug platform pm
command in privileged EXEC mode. To disable debugging, use the no form of this command.
debug platform pm {all| atom| counters| errdisable| etherchnl| exceptions| gvi| hpm-events| idb-events|
if-numbers| ios-events| link-status| platform| pm-events| pm-span| pm-vectors [detail]| rpc [general|
oper-info| state| vectors| vp-events]| soutput-vectors| stack-manager| sync| vlans}
no debugplatformpm{all| counters| errdisable| etherchnl| exceptions| hpm-events| idb-events| if-numbers|
ios-events| link-status| platform| pm-events| pm-span| pm-vectors [detail]| rpc [general| oper-info| state|
vectors| vp-events]| soutput-vectors| stack-manager| sync| vlans}
Syntax Description
Displays all port manager debug messages.all
Displays atom related events.atom
Displays counters for remote procedure call (RPC)
debug messages.
counters
Displays error-disabled-related events debug messages.errdisable
Displays EtherChannel-related events debug messages.etherchnl
Displays system exception debug messages.exceptions
Displays IPe GVI-related messages.gvi
Displays platform port manager event debug messages.hpm-events
Displays interface descriptor block (IDB)-related events
debug messages.
idb-events
Displays interface-number translation event debug
messages.
if-numbers
Displays Cisco IOS software events.ios-events
Displays interface link-detection event debug messages.link-status
Displays port manager function event debug messages.platform
Displays port manager event debug messages.pm-events
Displays port manager Switched Port Analyzer (SPAN)
event debug messages.
pm-span
Displays port manager vector-related event debug
messages.
pm-vectors
Catalyst 2960-X Switch Layer 2 Command Reference, Cisco IOS Release 15.0(2)EX
OL-29043 -01 35
Layer 2 Commands
debug platform pm
To Next Page
Loading...
Need help?
General