Cisco Catalyst 250 Series Command Reference

link state track
To enable a link-state group, use the link state track command in global configuration mode. Use the no
form of this command to disable a link-state group.
link state track [number]
no link state track [number]
Syntax Description
(Optional) Specifies the number of the link-state group. The range is 1 to 2. The
default is 1.
number
Command Default
Link-state tracking is disabled.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS 15.0(2)EX
Usage Guidelines
This command is supported only on the LAN Base image.
Use the link state group command to create and configure the link-state group. You then can use this command
to enable the link-state group.
Examples
This example shows how to enable link-state group 2:
Switch# configure terminal
Switch(config)# link state track 2
Switch(config)# end
Catalyst 2960-X Switch Layer 2 Command Reference, Cisco IOS Release 15.0(2)EX
48 OL-29043 -01
Layer 2 Commands
link state track

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English