Cisco Catalyst 250 Series Command Reference

show pagp
To display Port Aggregation Protocol (PAgP) channel-group information, use the show pagp command in
EXEC mode.
show pagp [channel-group-number] {counters| dual-active| internal| neighbor}
Syntax Description
(Optional) Number of the channel group. The range is 1 to 24.
channel-group-number
Displays traffic information.counters
Displays the dual-active status.dual-active
Displays internal information.internal
Displays neighbor information.neighbor
Command Default
None
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS 15.0(2)EX
Usage Guidelines
You can enter any show pagp command to display the active channel-group information. To display the
nonactive information, enter the show pagp command with a channel-group number.
Examples
This is an example of output from the show pagp 1 counters command:
Switch> show pagp 1 counters
Information Flush
Port Sent Recv Sent Recv
----------------------------------------
Channel group: 1
Gi1/0/1 45 42 0 0
Gi1/0/2 45 41 0 0
This is an example of output from the show pagp dual-active command:
Switch> show pagp dual-active
PAgP dual-active detection enabled: Yes
PAgP dual-active version: 1.1
Catalyst 2960-X Switch Layer 2 Command Reference, Cisco IOS Release 15.0(2)EX
64 OL-29043 -01
Layer 2 Commands
show pagp

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English