Cisco Catalyst 250 Series Command Reference

Examples
This example shows how to configure the LACP port priority on a port:
Switch# interface gigabitethernet2/0/1
Switch(config-if)# lacp port-priority 1000
You can verify your settings by entering the show lacp [channel-group-number] internal privileged EXEC
command.
Related Commands
DescriptionCommand
Assigns an Ethernet port to an EtherChannel group, or enables an
EtherChannel mode, or both.
channel-group
Configures the LACP system priority.
lacp system-priority
Displays LACP channel-group information.
show lacp
Catalyst 2960-X Switch Layer 2 Command Reference, Cisco IOS Release 15.0(2)EX
44 OL-29043 -01
Layer 2 Commands
lacp port-priority

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English