Cisco Catalyst 250 Series Command Reference

Examples
This example shows how to set the learning method to learn the address on the physical port within the
EtherChannel:
Switch(config-if)# pagp learn-method physical-port
This example shows how to set the learning method to learn the address on the port channel within the
EtherChannel:
Switch(config-if)# pagp learn-method aggregation-port
You can verify your settings by entering the show running-config privileged EXEC command or the show
pagp channel-group-number internal privileged EXEC command.
Related Commands
DescriptionCommand
Selects a port over which all traffic through the EtherChannel is sent.
pagp port-priority
Displays Port Aggregation Protocol (PAgP) channel-group information.
show pagp
Catalyst 2960-X Switch Layer 2 Command Reference, Cisco IOS Release 15.0(2)EX
50 OL-29043 -01
Layer 2 Commands
pagp learn-method

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English