Cisco Catalyst 9200 Series Installation Guide

Figure 39: Site Profile - Distribution Switches
Figure 40: Site Profile - Distribution Switches (with Routed Access)
Table 14: Default Configuration Loaded with Each Site Profile (Core Switches)
Standalone Collapsed Core Switch
(with ECMP Peer and Port Channel
Downlink)
Standalone Core Switch (with
ECMP Peers)
Setting
The hostname or device name you
provided as part of Quick Setup
The hostname or device name you
provided as part of Quick Setup
Hostname
EnabledEnabledUDLD
Recovery mode set to AutoRecovery mode set to AutoError Disable Recovery
Source Destination IPSource Destination IPPort Channel Load Balance
Version 2Version 2SSH
EnabledEnabledSCP
EnabledEnabledVTY Access to Switch
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
58
Configuring the Switch
Configuring Your Device Based on a Site Profile

Cisco Catalyst 9200 Series Specifications

General

Category	Switch
Stacking Bandwidth	160 Gbps
Layer	Layer 2 and Layer 3
Operating System	Cisco IOS XE
Operating Temperature	0°C to 45°C (32°F to 113°F)
Series	Cisco Catalyst 9200 Series
Ports	24 or 48 Ethernet ports
Switching Capacity	Up to 176 Gbps
PoE	PoE, PoE+, and UPOE
Stacking	StackWise-160
Memory	4 GB DRAM, 4 GB Flash
Network Management	Cisco DNA Center, WebUI, CLI
Security Features	802.1X, TrustSec, MACsec
Warranty	Limited Lifetime Warranty
Dimensions	1.73 x 17.5 x 11.3 in. (4.4 x 44.5 x 28.8 cm)