Cisco Catalyst 9200 Series Installation Guide

Figure 22: Network Module Serial Number Location
Installing and Removing SFP Modules
Installing SFP/SFP+ Modules
Before you begin
See the switch release notes on Cisco.com for the list of supported SFP and SFP+ modules. Use only supported
SFP/SFP+ modules on the switch. For the latest information about supported SFP and SFP+ modules, refer
to the Cisco Transceiver Modules Compatibility Information.
For information about installing, removing, cabling, and troubleshooting SFP/SFP+ modules, see the module
documentation that shipped with your device.
Class 1 laser product. Statement 1008
Warning
• Do not remove the dust plugs from the SFP/SFP+ modules or the rubber caps from the fiber-optic cable
until you are ready to connect the cable. The plugs and caps protect the module ports and cables from
contamination and ambient light.
• Removing and installing an SFP/SFP+ module can shorten its useful life. Do not remove and insert any
SFP/SFP+ module more often than is necessary.
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
35
Installing a Network Module
Installing and Removing SFP Modules

Cisco Catalyst 9200 Series Specifications

General

Category	Switch
Stacking Bandwidth	160 Gbps
Layer	Layer 2 and Layer 3
Operating System	Cisco IOS XE
Operating Temperature	0°C to 45°C (32°F to 113°F)
Series	Cisco Catalyst 9200 Series
Ports	24 or 48 Ethernet ports
Switching Capacity	Up to 176 Gbps
PoE	PoE, PoE+, and UPOE
Stacking	StackWise-160
Memory	4 GB DRAM, 4 GB Flash
Network Management	Cisco DNA Center, WebUI, CLI
Security Features	802.1X, TrustSec, MACsec
Warranty	Limited Lifetime Warranty
Dimensions	1.73 x 17.5 x 11.3 in. (4.4 x 44.5 x 28.8 cm)