Cisco Catalyst 9400 Series User Manual

Step 6 Verify that you have the correct AC power cord for your location and power supply rating and only then plug
the power cord connector into the power supply AC-in receptacle.
--Power cord, plugged into the AC-in
receptacle
1
Step 7 Strap in the power cord retainer, to hold it in place and avoid accidental removal.
See Power Cord Retainer Mechanism, on page 105
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
104
Removing and Replacing FRUs
Installing an AC-Input Power Supply Module

Cisco Catalyst 9400 Series Specifications

General

Series	Catalyst 9400 Series
Form Factor	Rack-mountable
Operating System	Cisco IOS XE
Uplink Options	40G and 100G uplinks
Stacking	Not supported
Layer Support	Layer 2 and Layer 3
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 90% noncondensing
Power Supply Options	AC and DC power supplies
Redundancy	Power supply, supervisor engine
Modular Slots	7 or 10
MAC Address Table Size	256, 000
Security Features	ACLs, TrustSec, MACsec
Management	CLI, SNMP, NETCONF, RESTCONF, Cisco DNA Center