Cisco Catalyst CW9800H1 - Supported Hardware Components; Supported EPA

CHAPTER 2
Supported Hardware Components
This chapter contains information about the supported hardware components on the .
• Supported EPA, on page 19
• Supported SFP Models, on page 20
• Supported Transceivers, on page 22
• Power Supplies, on page 24
Supported EPA
The following table lists the supported EPA on the Cisco Catalyst CW9800H1 Wireless Controller and the
Cisco Catalyst CW9800H2 Wireless Controller.
DescriptionPID
Eight 1 GE/10 GE-ports that support small form-factor pluggable (SFP+)
optical transceivers to provide network connectivity. Ports are numbered
0 – 7.
See the Supported SFP Transceivers section, for supported transceivers.
EPA-8X1 GE or 10GE
(Applies to both Cisco Catalyst
CW9800H1 Wireless Controllers
and the Cisco Catalyst CW9800H2
Wireless Controllers)
Four 25 GE-ports that support SFP optical transceivers to provide
network connectivity.
• Bay 1—3 X 25-GE SFP ports.
The supported ports are:
• TwentyFiveGigE0/1/0—25-GE SFP+ Port 0
• TwentyFiveGigE0/1/1—25-GE SFP+ Port 1
• TwentyFiveGigE0/1/2—25-GE SFP+ Port 2
• Bay 2—1 X25-GE SFP port.
The supported port is TwentyFiveGigE0/2/0—25-GE SFP+ Port
0.
See the Supported SFP Transceivers section, for supported transceivers.
EPA-4X25 GE
(Applies to Cisco Catalyst
CW9800H1 Wireless Controllers
only)
Cisco Catalyst CW9800H1 and CW9800H2 Wireless Controllers Hardware Installation Guide
19