Device# show running-config
.
.
.
license boot level adventerprise
Table 19: show running-config Command Output Description
DescriptionField Name
Indicates the current requested Cisco lOS license level to boot.license boot level adventerprise
Viewing License Information
Use the show license udi command to determine the Universal Device Identifier (UDI) information of your
chassis. This may be required at the time of purchasing a new license.
The following example displays sample output from the show license udi command:
Evaluation License Features
The wireless controller operates on evaluation mode when the device is not registered. The evaluation mode
is for 90 days. After the expiry of the evaluation period, if the wireless controller is not registered to a smart
account, the wireless controller will start displaying syslog evaluation expiration messages. These error
messages are purely for informational purpose only and will not affect the functionality of the wireless
controller.
The number of APs supported on the wireless controller when the wireless controller is on EVAL mode will
be equal to the capacity of the wireless controller and the wireless controller will be fully operational. No
other license is required to use the wireless controller in evaluation mode.
Cisco Catalyst CW9800H1 and CW9800H2 Wireless Controllers Hardware Installation Guide
78
License Verification
Viewing License Information
To Next Page
Loading...
