Cisco CDE 220 Series User Manual

4-12
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
Chapter 4 Installing the VDS Internet Streamer Software and Initially Configuring a CDE
Launching a New CDE for the First Time
Step 4 In the Trap Destinations area, select the row of the desired SNMP trap destination.
Step 5 Click Send SNMP Test Trap.
An SNMP test trap message is sent to the trap destination.
Note The trap must be configured and enabled in order to send a test message.
Managing SNMPv3 Users
Before You Begin, check the following
• You must log in as a user with admin privileges to perform this task.
• SNMP must be enabled.
Procedure
Step 1 In the Navigation pane, click the Admin tab.
Step 2 On the Admin tab, click Communications Services.
Step 3 In the Communications Services pane, click the SNMP tab.
Step 4 In the SNMPV3 Users area, update the following properties:
Step 5 Click Save Changes.
Configuring SNMPv3 Users
Before You Begin, check the following:
• You must log in as a user with admin privileges to perform this task.
Table 4-3 SNMPV3 Users Properties
Name Description
Add button Click an available row in the table then click this
button to add a new SNMP user.
Modify button Select the user you want to change in the table
then click this button to modify the selected
SNMP user.
Delete button Select the user you want to delete in the table then
click this button to delete the selected SNMP user.
ID column The system-assigned identifier for the SNMP
user.
Name column The SNMP user name.
Auth Type column The user authentication type.
Privacy Type column The user privacy type.

Cisco CDE 220 Series Specifications

General

Brand	Cisco
Model	CDE 220 Series
Category	Server
Language	English