Cisco Codec C60 - The DNAM Loudspeaker

86
Cisco TelePresence System Codec C60/C40 and Profiles using C60/C40 Administrator guide
D14636.06 Profile C60-C40 and Codec C60-C40 Administrator Guide TC4.2, July 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
The DNAM Amplifier
• 3 × 50 W continuous average Center Output
Power (load specified by DNAM Center
Loudspeakers)
• 2 × 50 W continuous average Stereo Output
Power (load specified by DNAM Stereo
Loudspeakers)
• Full dynamic range for audio (20 Hz–20 kHz)
• Digital Signal Processing and Filtering on all
channels for best audio detail clarity
• Digital Crossover Filtering on center
channels
• In/out:
• Audio In - SPDIF (stereo) or Analog
(mono), using the same connector.
• Audio Loop Out - line out directly from
the input, always analog even with
SPDIF in.
• Audio Differential In - female XLR
pinout: 1 - GND, 2 – Signal (+), 3 –
Signal (-)
• Audio Stereo Out - male XLR, common
GND configuration
• Loudspeaker Out - female D-SUB 15p
• Fuse 2 A 250 V Slow, 5 × 20 mm, Littelfuse
type 215002. Push and twist anti-clockvice
to release.
DNAM for Profile 42”/52”
The DNAM – Digital Natural Audio Module – is
built on two specially designed and separate
modules, the amplifier and the loudspeaker
cabinet.
The DNAM Loudspeaker
• 3-way Center Loudspeaker system
• Frequency range 50 Hz - 20 kHz
• 2 × 100 mm low- and midrange
loudspeaker 8 Ohms nominal, excellent
quality (SEAS Prestige series)
• 1 × 25 mm dome tweeter, 6 ohms nominal,
excellent quality
• Active crossover filtered audio signals
received from DNAM amplifier
• Long time max power 70 Watt on all
loudspeakers
• Enclosed MDF loudspeaker cabinet
Integrated Left / Right Stereo Loudspeaker
Stereo Loudspeaker System, each side has:
• 1 × 90 mm fullrange loudspeaker, 8 Ohms
nominal, excellent quality
• Frequency range 70 Hz - 20 kHz
• Enclosed MDF Loudspeaker cabinet
Power socket
DNAM Amplifier
DNAM Loudspeaker
Fuse
Audio Stereo Out (XLR)
Audio Differential In (XLR)
Loudspeaker Out
(D-SUB)
Audio In
(RCA)
Audio Loop Out
(RCA)