EasyManua.ls Logo

Cisco CRS-1 - Carrier Routing System Router

Cisco CRS-1 - Carrier Routing System Router
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7-167
Cisco IOS XR Troubleshooting Guide for the Cisco CRS-1 Router
OL-21483-02
Chapter 7 Collecting System Information
Using Diagnostic Commands
RP/0/RP0/CPU0:router(admin)#diagnostic start location
0/RP0/CPU0
test non-disruptive
Wed Sep 1 12:50:24.156 PDT
RP/0/RP0/CPU0:Sep 1 12:50:24.426 : online_diag_rp[351]:
%DIAG-DIAG-6-TEST_SKIPPED_FROM_ACTIVE : RP 0/RP0/CPU0: ControlEthernetInactiveLinkTest
cannot be executed from active node.
RP/0/RP0/CPU0:Sep 1 12:50:24.426 : online_diag_rp[351]:
%DIAG-DIAG-6-TEST_SKIPPED_FROM_ACTIVE : RP 0/RP0/CPU0: FabricDiagnosisTest cannot be
executed from active node.
RP/0/RP0/CPU0:Sep 1 12:50:24.428 : online_diag_rp[351]:
%DIAG-DIAG-6-TEST_SKIPPED_FROM_ACTIVE : RP 0/RP0/CPU0: FabricMcastTest cannot be
executed from active node.
RP/0/RP0/CPU0:Sep 1 12:50:24.430 : online_diag_rp[351]: %DIAG-DIAG-6-TEST_RUNNING :
RP 0/RP0/CPU0: Running ControlEthernetPingTest{ID=1} ...
RP/0/RP0/CPU0:Sep 1 12:50:28.703 : online_diag_rp[351]: %DIAG-DIAG-6-TEST_OK : RP
0/RP0/CPU0: ControlEthernetPingTest{ID=1} has completed successfully
RP/0/RP0/CPU0:router(admin)#show diagnostic result location
0/RP0/CPU0
Wed Sep 1 12:51:41.606 PDT
Current bootup diagnostic level for RP 0/RP0/CPU0: bypass
RP 0/RP0/CPU0:
Overall diagnostic result: MINOR ERROR
Diagnostic level at card bootup: bypass
Test results: (. = Pass, F = Fail, U = Untested)
1 ) ControlEthernetPingTest ---------> .
2 ) SelfPingOverFabric --------------> .
3 ) FabricPingTest ------------------> .
4 ) ControlEthernetInactiveLinkTest -> U
5 ) RommonRevision ------------------> F
6 ) FabricDiagnosisTest -------------> U
7 ) FilesystemBasicDisk0 ------------> .
8 ) FilesystemBasicDisk1 ------------> .
9 ) FilesystemBasicHarddisk ---------> .
10 ) ScratchRegisterTest:
Device 1 2 3 4
------------------
. . . .
11 ) FabricMcastTest -----------------> U
The following example shows a set of diagnostic tests on the standby RP (0/RP1/CPU0).
RP/0/RP0/CPU0:router(admin)#diagnostic start location
0/RP1/CPU0
test non-disruptive
Wed Sep 1 12:50:52.703 PDT
RP/0/RP1/CPU0:Sep 1 12:50:54.242 : online_diag_rp[351]: %DIAG-DIAG-6-TEST_RUNNING :
RP 0/RP1/CPU0: Running ControlEthernetPingTest{ID=1} ...
RP/0/RP1/CPU0:Sep 1 12:50:58.686 : online_diag_rp[351]: %DIAG-DIAG-6-TEST_OK : RP
0/RP1/CPU0: ControlEthernetPingTest{ID=1} has completed successfully
RP/0/RP1/CPU0:Sep 1 12:50:58.686 : online_diag_rp[351]: %DIAG-DIAG-6-TEST_RUNNING :
RP 0/RP1/CPU0: Running SelfPingOverFabric{ID=2} ...
RP/0/RP0/CPU0:Sep 1 12:50:58.809 : online_diag_rp[351]: %DIAG-DIAG-6-TEST_OK : RP
0/RP0/CPU0: SelfPingOverFabric{ID=2} has completed successfully
RP/0/RP0/CPU0:Sep 1 12:50:58.809 : online_diag_rp[351]: %DIAG-DIAG-6-TEST_RUNNING :
RP 0/RP0/CPU0: Running FabricPingTest{ID=3} ...
RP/0/RP0/CPU0:Sep 1 12:51:00.672 : online_diag_rp[351]: %DIAG-DIAG-6-TEST_OK : RP
0/RP0/CPU0: FabricPingTest{ID=3} has completed successfully

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Related product manuals